Removing And Installing The Drive Block (Front) - Siemens SIMATIC PC RI25/45 Technical Description

1.3.6

Removing and Installing the Drive Block (Front)

Procedure Proceed as follows to replace the drive block:
Figure 1-9 Mounting the front drive block
SIMATIC PC RI25/45, Technical Description
C79000-G7076-C808-01
Release the screw on the bottom of the housing (do not unscrew it
completely).
Mounting screw
First pull the drive block two centimeters (0.8 inches) to the rear (see
direction of arrow in Figure 1-9) then pull the front block out of the housing.
To replace the drive, or to install a second drive (for example, a CD-ROM
drive), release the two upper and the two lower screws.
Then remove the 3.5" support which lodges the hard disk drive and release
the four screws which connect hard disk drive and support.
5.25" drives or CD-ROM drives do not require any support.
To install the drive block, proceed in reverse order .
System Unit
1-11