Siemens SIMATIC PC RI25/45 Technical Description page 112

CD-ROM Drive
Emergency Eject
The procedure described below can be used to remove a disc from the CD-ROM
reader if the Open/Close button is disabled by software or a power failure occurs.
In this case the CD tray cannot be opened automatically.
1. Turn off the power to the CD-ROM reader (switch off your device if
2. Insert a steel rod or a stiff paper clip (with a maximum diameter of 1.3 mm
Operating Your
By pushing the Open/Close button the CD tray is smoothly opened. Place the CD
CD-ROM Drive
with the labeled side upward into the tray. Do not use the built-in clips. The tray
is closed automatically after a short push or after having pushed the Open/Close
button.
Vorsicht
!
Risk of data loss and damage to the drive!
CD-ROM drives are sensitive to vibrations and shock. Any vibrations occuring
during operation can lead to damage to the drive or CD.
Additional Slots The PC is equipped with additional slots for disk drives and expansion modules.
For further information refer to Chapter 4 of the manual.
7-4
necessary).
and a minimum length of 55 mm) into the emergency eject hole at the front
of the drive and push lightly. The CD tray is ejected by about 10 mm. Pull
it all the way open by hand and lift the disc out carefully.
At least 55 mm
in length
SIMATIC PC RI25/45, Technical Description
C79000-G7076-C808-01