Setup
4. Once the proper drum height is achieved, slide the
Drum Access Panel onto the hex shaft and door pin.
5. Tighten four bolts on Drum Access Panel (H).
6. Non-DCS Models:Turn Drum Adjustment Dial (D)
to maximum height.
DCS Models: Press the Home Button (S) on the
DCS Control (D).
Removal
To avoid unexpected start up, disconnect spark plug
wire before you service your unit.
1. Remove four bolts and Drum Access Panel (H).
2. Slide drum off of hex shaft.
8
ti15257a
ti14767a
ti14765a
Depth Control Wheels
Using Depth Control Wheels as a 5 in. or 10
in. Wide Cutting Guide
To make a 5 in. cut, install two spacers (S) on outside
of Depth Control Wheels (K).
K
S
To make a 10 in. cut, install two spacers (S) on inside
of Depth Control Wheels (K).
K
S
How to Level the Drum
To properly level the drum, GrindLazer must be resting
on a flat level surface.
Depth Control Wheels Adjustment
1. Make sure drum is properly installed (see Drum
Replacement, page 7).
2. Push down on handle bars, pull engagement lever,
and lower drum into DOWN position.
K
ti15095a
5 in.
K
S
ti15094a
10 in.
3A5918B
S