Component Identification (Dcs Models) - Graco GrindLazer 25M992 Operation Manual

Component Identification (DCS Models)

Component Identification (DCS Models)
25N658
Component
A Engine Throttle Lever
B Power Switch
C Engine Kill Button
D DCS Control
E Drum Engage Lever
F Front Wheel Lock Lever
G Rear Wheel Parking Brake
H Drum Access Panel
K Depth Control Wheels
M Vacuum Port
N Lift Points
P Ignition Switch
R Tachometer/Hour Meter
S Home Button
T Zero Button
U Cut Depth Button
V Up/Down Buttons
W Manual Height Adjustment
6
Adjusts engine speed.
Supplies power to DCS Control and Engine.
Clamps onto the operator and shuts engine off if cord is disconnected during operation.
Controls and displays depth of drum cut.
Handle bars can be pushed down to raise the cutting drum off of surface and locked into UP
position. Once drum is locked in UP position, GrindLazer can be moved around without drum
touching surface. To lower the drum to the surface, push down on handlebars, engage the
Drum Engage Lever and then slowly pull the handlebars up.
Front wheel is usually locked to guide GrindLazer in a straight line. When lever is engaged,
front wheel becomes unlocked and is allowed to turn freely.
Prevents rear wheel from moving.
Removable plate that allows access to replace cutting drum.
Levels cutting drum.
Port to attach vacuum to reduce dust and debris during operation.
Reinforced points used for lifting GrindLazer during transportaton or repair.
Electric Start Engine.
Displays the RPMs of the engine while running and displays total hours of engine run time.
Raises drum off the surface to highest position.
Brings the drum to the surface (reprogrammable).
Lowers drum to the desired cut depth target (reprogrammable).
Raises or Lowers the drum.
Remove screw plug to adjust drum height using 6mm hex key.
25N659
Description
3A5918B