Weekly program (cont.)
Adjusting "US type" daily programs – Start time / Stop time / Mode / Fan speed / Setpoints
Start time
1. Press the [C/F – Prog] button. The programmed weekday(s), "Prog 1" indicating the
first program event of the day and the word "Start" will appear on display.
The HOURS will flash.
Note: If this is the first time a program is being set, the symbols "--" will flash.
2. Use the [+] and [-] buttons to adjust the start time hours of the first event.
3. Press the [C/F – Prog] button again. The MINUTES will flash.
4. Use the [+] and [-] buttons to adjust the start time minutes of the first event.
System mode
5. Press the [C/F – Prog] button again. The system MODES will flash.
6. Use the [+] and [-] buttons to select the system mode of the first event
7. Press the [C/F – Prog] button again. The FAN SPEEDS will flash.
8. Use the [+] and [-] buttons to select the fan speed of the first event.
Follow the steps above for setpoint temperatures.
Follow the steps above for the other schedule events of the same daily events
(Prog 2 for two events per day, or Prog 2, 3 and 4 for four events per day).
Follow the steps above for all daily periods.
- 16 -