Manitowoc QuietQube Series Technician's Handbook page 41

Step 1
Open the front door to access the evaporator
compartment. Ice must not be on the evaporator during
the clean/sanitize cycle. Follow one of the methods below:
• Press the power switch at the end of a harvest cycle
after ice falls from the evaporator(s).
• Press the power switch and allow the ice to melt.
• Use the touchscreen to initiate a manual harvest cycle.
Never use anything to force ice from the evaporator.
Damage may result.
Step 2 Remove all ice from the bin/dispenser.
Step 3 Press the Clean button and select "Turn off
when complete". Water will flow through the water dump
valve and down the drain. Wait approximately 1 minute
until the water trough refills and the display indicates Add
Chemical. Add the proper amount of ice machine cleaner
to the water trough by pouring between the water curtain
and evaporator, then confirm the chemical was added.
NOTE: There is a 10 minute time limit to confirm chemical
was added.
• Confirmation is pushed within 10 minutes - The ice
machine will start a 10 minute wash cycle, followed by
6 rinse and flush cycles.
• Confirmation is not pushed within 10 minutes - The ice
machine will skip the 10 minute wash cycle and start 6
rinse and flush cycles.
Step 4
Model
IF0600C/IBF0620C/IBF0820C
IF0900C/IBT1020C/IT1200C
IF1400C/IF1800C/IF2100C
Part Number: 000015431 Rev01 5/19

Notice
Amount of Cleaner
5 ounces (150 ml)
9 ounces (265 ml)
41