Manitowoc QM30 Installation And Use Manual
Undercounter model ice machines
Hide thumbs
Also See for QM30:
- Installation, operation and maintenance manual (32 pages) ,
- Installation and use manual (28 pages) ,
- Technician's handbook (236 pages)
Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for Manitowoc QM30
Summary of Contents for Manitowoc QM30
- Page 1 QM30 UnderCounter Model Ice Machines Installation, Use & Care Manual This manual is updated as new information and models are released. Visit our website for the latest manual. www.manitowocfsg.com America’s #1 Selling Ice Machine Part Number 000001772 07/08...
-
Page 2: Safety Notices
Safety Notices Read These Before Proceeding: As you work on Manitowoc equipment, be sure to pay close attention to the safety notices in this manual. ! Caution Disregarding the notices may lead to serious injury and/ Proper installation, care and maintenance are or damage to the equipment. - Page 3 Table of Contents Section 1 General Information Model/Serial Number Location ..............Owner Warranty Registration Card ............Section 2 Installation Instructions General ......................... Dimensions ......................Location of Ice Machine ................Ice Machine Heat of Rejection ..............Leveling the Ice Machine ................Electrical Service .....................
-
Page 4: Table Of Contents
Table of Contents (continued) Section 4 Maintenance Interior Cleaning and Sanitizing ..............GENERAL ……………………………………………………………………… CLEANING AND SANITIZING PROCEDURE ……………………………… Exterior Cleaning ................Ice Machine Inspection ..............Cleaning The Condenser ..............Removal from Service/Winterization ............Section 5 Before Calling for Service Checklist ...................... -
Page 5: General Information
Section 1 General Information Model/Serial Number Location Record the model and serial number of your ice machine The model and serial number are listed on the OWNER in the space provided below. These numbers are WARRANTY REGISTRATION CARD. They are also required when requesting information from your listed on the MODEL/SERIAL NUMBER DECAL affixed Manitowoc distributor, service representative, or the... -
Page 6: Owner Warranty Registration Card
(3) years from the date is not authorized to perform warranty service, contact of original installation. your Manitowoc distributor or Manitowoc Ice, Inc. for the name of the nearest authorized service representative. SERVICE CALLS Normal maintenance, adjustments and cleaning as outlined in this manual are not covered by the warranty. -
Page 7: Part Number 000001772
Subject to the exclusions and limitations below, maintenance, (2) repair or replacement of the Product or Manitowoc Ice, Inc. (“Manitowoc”) warrants to the parts due to normal wear and tear, (3) defects or original consumer that any new ice machine damage to the Product or parts resulting from misuse, manufactured by Manitowoc (the “Product”) shall be free... -
Page 8: Part Number 000001772
General Information Section 1 THIS PAGE INTENTIONALLY LEFT BLANK Part Number 000001772 07/08... -
Page 9: Installation Instructions
Section 2 Installation Instructions General These instructions are provided to assist the qualified installer. Dimensions 50.00cm 79.00cm 57.00cm Part Number 000001772 07/08... -
Page 10: Location Of Ice Machine
Installation Instructions Section 2 Location of Ice Machine Ice machines, like other refrigeration equipment, reject heat through the condenser. It is helpful to know the The location selected for the ice machine must meet the amount of heat rejected by the ice machine when sizing following criteria. -
Page 11: Electrical Service
Section 2 Installation Instructions Electrical Service Warning Warning All wiring must conform to local, state and national Never use an extension cord. If an outlet is not codes. within reach of the ice machine’s power cord, have a proper amperage outlet wired closer to the ice machine. - Page 12 Installation Instructions Section 2 ELECTRICAL CORD STRAIN RELIEF TERMINAL BLOCK WIRE CONNECTION To prevent strain at the electrical connection inside the Warning ice machine, an electrical cord strain relief device must Always disconnect power to the ice machine before be installed on the rear panel of the ice machine. working on electrical circuitry.
- Page 13 Section 2 Installation Instructions Water Service/Drains WATER SUPPLY Local water conditions may require treatment of the • Install a water shut-off valve for both the ice making water to inhibit scale formation, filter sediment, remove and condenser water lines (if applicable). chlorine, and improve taste and clarity.
- Page 14 Installation Instructions Section 2 OVERFLOW TUBE DRAIN HOLE ICE MAKING/BIN WATER DRAIN TUBING 1.59 cm (5/8”) MINIMUM INSIDE DIAMETER ICE MAKING WATER INLET TUBING 0.95 cm (3/8”) MINIMUM INSIDE DIAMETER Typical Water Supply and Drain Line Sizing and Connections Part Number 000001772 07/08...
-
Page 15: Operation Section
Section 3 Operation Sequence of Operation Control Board Relays Ice Making Sequence Length of of Operation Hot Gas Valve Water Pump Compressor “ON” Time Water Fill Valve Fan Motor Start-Up* 2.9 Minutes 1.Water Purge (175 Seconds) 2.Refrigeration 5 Seconds System Start-Up 3.Freeze Cycle Automatically deter- mined... -
Page 16: Ice Thickness Adjustment
QM30 dice ice cube formation is slightly different from 4. Remove the air filter. our previous models. Manitowoc ice machines have a 5. Remove the two screws holding the front panel in unique cube shape. It is normal to have a dimple in the place and remove the front cover. -
Page 17: Maintenance
4 Wait until water flows over the evaporator (about three minutes) then add the proper amount of GENERAL Manitowoc Ice Machine Cleaner to the water trough. Clean and sanitize the ice machine every six months for Model Amount of Cleaner efficient operation. - Page 18 WASH position. to the walls of the cabinet. step 15 Add the proper amount of Manitowoc Ice step 7 Mix a solution of cleaner and warm water. Machine Sanitizer to the water trough.
-
Page 19: Exterior Cleaning
Section 4 Maintenance step 18 Mix a solution of sanitizer and warm water. Exterior Cleaning Clean the area around the ice machine as often as Solution Type Water Mixed With necessary to maintain cleanliness and efficient 120 ml (4 oz) san- Sanitizer 23L. -
Page 20: Cleaning The Condenser
Maintenance Section 4 Cleaning The Condenser 4. Use a commercial condenser coil cleaner. Follow the directions and cautions supplied with the Warning cleaner. Disconnect electric power to the ice machine at the 5. Straighten any bent condenser fins with a fin comb. electric service switch... -
Page 21: Before Calling For Service
Section 5 Before Calling for Service Checklist If a problem arises during operation of your ice machine, follow the checklist below before calling for service. Problem Possible Cause To Correct Ice machine does not operate No electrical power to the ice machine Replace the fuse/reset the breaker/turn on the main switch Toggle switch set improperly... - Page 22 Before Calling for Service Section 5 Problem Possible Cause To Correct Ice machine produces shallow or Water level is low Be sure the overflow tube is fully seated to incomplete cubes, or the ice fill prevent water leakage pattern on the evaporator is Water inlet valve filter screen is dirty Remove the water inlet valve and clean incomplete...
- Page 24 © 2007 Manitowoc Continuing product improvements may necessitate change of specifications without notice. Part Number 000001772 07/08 Manitowoc Foodservice Group 2110 South 26th Street, P.O. Box 1720 Manitowoc, WI 54221-1720, USA Ph: 920-682-0161 Fax: 920-683-7589 Visit us online at: www.manitowocfsg.com...