Table of Contents
Advertisement
Chapter 5 Scanning Control
Scanning is controlled by trigger switch control. (Section 5.1)
5.1 Trigger Switch Control
Pressing the trigger switch when the scanner is turned on turns on the illumination LEDs and readies the scanner for scanning.
The scanner supports the following three trigger switch operating modes. Select the one that best meets your needs using the
Bar-coded parameter menu or the configuration software (Scan Tune App).
(1) Auto-off mode
When the trigger switch is pressed, the scanner is brought to the Active state for approximately five seconds.
The scanner automatically returns to the Ready state when scanning is successfully completed, or after approximately five
seconds elapsed with the trigger switch pressed.
The scanner goes to the Ready state if the trigger switch is released before five seconds elapses.
(2) Momentary switching mode
The scanner is brought to the Active state only when the trigger switch is pressed, and returns to the Ready state when the
trigger switch is released.
(3) Alternate switching mode
The scanner alternates between the Active state and the Ready state every time the trigger switch is pressed.
Note:
· When you are setting parameters using the Bar-coded parameter menu, the scanner is always in the auto-off mode
regardless of the trigger switch operating mode selected.
· Establishing the Bluetooth
trigger switch control.
®
wireless link or selecting the "Scan w/ Bluetooth
®
15
link broken" parameter enables the
Advertisement
Table of Contents
