Installation Procedure; Disposal - Danfoss AME 110 NL Datasheet

Data sheet

Installation procedure

Disposal

Wiring
Commissioning
SMT/SI
Actuators for modulating control AME 110 NL, AME 120 NL
1. Check the valve neck. The actuator should be
in stem up position (factory setting).
Ensure that the actuator is mounted securely
on the valve body
2. Wire the actuator according to the
wiring diagram
3. The direction of the stem movement can be
observed on the position indicator
The actuator must be dismantled and the
elements sorted into various material groups
before disposal.
The factory setting of the spindle is the fully
stem up position because of easier mechanical
connection of the actuator on the valve.
VD.KH.C6.02 © Danfoss 01/2014
position
indicator
3