Maintenance; Routine Maintenance Overview Checklist - MTS Systems Exceed 40 Series Product Manual

Maintenance

Routine Maintenance Overview Checklist

C T U
ALENDAR IME SING
R D
ATE PER AY
R T -H
UNNING IME OURS
Check shunt calibration
Clean work area/machine surface
Activate and reset limits and Emergency-Stop
Inspect cable/connections
PC Maintenance
Back up testing software files (*.reg/.cal files)
Hard drive defragment
System Inspection
Check/adjust drive belt tension (refer to table)
Inspect drive belts for excessive wear
Inspect cable connections
System Checks
Check Emergency-Stop
Check upper limit
Check lower limit
Check load cal/shunt cal
Lubrication
Crosshead/ball screw (#2 white lithium grease)
Drivetrain bearings (if applicable)
Frame and Work Area
Clean off frame and work area
* Denotes services performed by equipment operators. Most of these procedures involve visual checks
that should not interfere with testing system operation. These checks are also completed by trained
field service engineers on each Routine Maintenance visit.
† Denotes service performed by trained field service engineers as part of an MTS Routine Maintenance
plan. Some of these procedures require special service tools and/or specific service training to
complete.
MTS Exceed™ Series 40 Product Manual
Recommended Service
8 H R T
OURS UNNING IME
Routine Maintenance Overview Checklist
D W
AILY EEKLY
8 40
*
X
X
X
X
A
NNUALLY
2000
†
MTS
MTS
MTS
MTS
MTS
MTS
MTS
MTS
MTS
MTS
MTS
MTS
Maintenance 75