Operation - MTS Systems Exceed 40 Series Product Manual

Operation

Contents
MTS Exceed™ Series 40 Product Manual
This section describes the actions performed during normal, day-to-day
operation of the MTS Exceed frame. For information on using the MTS
Exceed frame in actual testing, refer to the testing software manual.
Main Power Switch (I/O) and Emergency-Stop
Setting Crosshead Travel Limits
Crush Zone Hazards
Fixture Mounting 72
Handset Control 73
There are rotating parts inside the machine.
Operating the machine without side covers or bellows in place can expose
the operator to rotating parts that could cause injury if contact is made.
Do not operate the MTS Exceed test frame without the side covers and bellows in
place.
Specimen debris can enter the side covers and puncture bellows causing
erratic machine operation.
Material fragments can puncture the bellows and damage the ball screw.
Damaged bellows should be replaced before operating the MTS Exceed Test
Frame. Be aware of the potential of material fragments puncturing the bellows and
damaging the ball screw, and be aware of the material properties and the hazards
generated by the materials during testing.
There are potential hazards during material testing.
Hazards generated by the materials during testing can cause injury or
death.
Ensure that only qualified, trained personnel should be allowed to operate the
machine. Keep bystanders away during machine operation.
69
71
CAUTION
CAUTION
WARNING CAUTION
68
Operation 67