Maintenance - Hyundai HYT140 User Manual

6.

MAINTENANCE

The machine may be tipped backward or on its side to facilitate access for cleaning or service, but no longer
than 2 minutes. If the machine is held in this position for too long, the engine can be damaged by petrol draining
into the crankcase. Should this happen, perform an extra oil change on the engine over a few revolutions with
the starter handle before starting the engine again.
ALWAYS stop the engine and unplug the spark plug before doing any repairs or maintenance.
NEVER touch a rotating blade.
Check and maintain fuel & oil levels regularly, and maintain the correct levels.
Frequently check at regular intervals for the tightness of all nuts, bolts and screws.
If the machine vibrates badly stop the machine and take it to a service dealer.
ALWAYS refuel in a well-ventilated area with the engine off and spark plug HT cap removed.
Whilst carrying out maintenance you MUST wear appropriate Personal Protective Equipment (PPE). Suggested
PPE Sturdy footwear, work gloves, long trousers and hearing protection.
NEVER use a pressure washer or hose pipe to clean the machine. Water can penetrate the power unit and cause
damage the engine. Shut down the engine, wait for all moving parts to come to a complete stop, remove HT
lead, and then wait for 5 minutes before performing maintenance on the tiller.
Guards and Shields: Make sure all guards and shields are replaced after servicing the tiller. Keep your tiller
upright: NEVER lay your tiller on its side while moving, storing, or using it. Oil could leak and damage your tiller
engine and surrounding areas. You MUST comply with local and current regulations that apply to the use of
your tiller. There may be additional regulations that apply if your tiller is used on construction sites.
Spare parts - If a part needs replacement, you MUST only use parts that meet the manufacturer's part number
specifications. Replacement parts that DO NOT meet specifications may result in a safety hazard or poor
operation of the tiller and will VOID the warranty. Major servicing including installation or replacement of parts,
should be made by a qualified service technician.
NOTE
WARNING
CAUTION
CAUTION
NOTE
Page 19 Ver 3 - 2017