Maintenance - Hyundai HYT140 User Manual

7. MAINTENANCE

NOTE
The machine may be tipped backward or on its side to facilitate access for cleaning
or service but for no longer than 2 minutes.
If the machine is held in this position for too long, the engine can be damaged by
petrol draining into the crankcase. Should this happen, perform an extra oil change
before starting the engine again.
WARNING
ALWAYS stop the engine and remove the HT lead cap from the spark plug before
doing any repairs or maintenance.
NEVER touch a rotating blade.
Check and maintain fuel & oil levels regularly.
Frequently check, at regular intervals, the tightness of all nuts, bolts and screws.
If the machine vibrates badly, stop the machine and take it to a service dealer.
CAUTION
ALWAYS refuel in a well-ventilated area with the engine off and the spark plug HT
lead cap removed.
Whilst carrying out maintenance, you MUST wear appropriate Personal Protective
Equipment (PPE). Suggested PPE but not limited to, Sturdy footwear, work gloves,
long trousers and hearing protection.
CAUTION
NEVER use a pressure washer or hose pipe to clean the machine. Water can
penetrate the power unit and cause damage to the engine.
Shut down the engine, wait for all moving parts to come to a complete stop,
remove the spark plug HT lead cap and then wait for 5 minutes before performing
maintenance on the tiller.
Make sure all guards and shields are replaced after servicing the tiller.
Keep your tiller upright, NEVER lay your tiller on its side while moving, storing or
using it.
Oil could leak and damage your tiller engine and surrounding areas.
You MUST comply with local and current regulations that apply to the use of your
tiller. There may be additional regulations that apply if your tiller is used on
construction sites.
NOTE
If a part needs replacement, you MUST only use parts that meet the manufacturer's
part number specifications. Replacement parts that DO NOT meet specification may
result in a safety hazard or poor operation of the tiller and will VOID the warranty.
Major servicing, including installation or replacement parts, should be made by a
qualified service technician.
22