Table of Contents
Advertisement
Ethernet Interface
Connector Type: RJ45
Cable Type: CAT5e Ethernet Cable: Length >1 .5m
Isolation: 1 .5kV
Data Rate: 10/100Mbps
Description
Pin 1:
TxD+
Pin 2:
TxD–
Pin 3:
RxD+
Pin 4:
N/C
Pin 5:
N/C
Pin 6:
RxD–
Pin 7:
N/C
Pin 8:
N/C
Wireless Ethernet Interface (where fitted)
Antenna:
Type: Integrated Diversity Dipole Antenna
RF Card:
Frequency Range: ISM Band 2 .4 to 2 .4897MHz
Modulation: CCK
Available Transmit Power: 100mW (20dbm)
Certification of the RF card:
The wireless LAN PCMCIA card installed in the Workstation is in compliance with the essential requirements and other relevant
provisions of Radio and Telecom Terminal Equipment Directive 1999/5/EC .
Auxiliary Interface
Connector Type: RJ45
Cable Type: CAT5e Ethernet Cable: As required
Isolation: 1 .5kV
Description
Pin 1:
Tx+
Pin 2:
Tx–
Pin 3:
Rx+
Pin 4:
N/C
Pin 5:
N/C
Pin 6:
Rx–
Pin 7:
N/C
Pin 8:
N/C
NOTES:
Assumes client equipment is non-medical equipment and outside of the patient environment; may be less than 1 .5m if the client
1
equipment is medical electrical equipment in compliance with EN 60601 .
Workstation may be used anywhere inside the patient environment .
2
Either a cross-over or straight through RS232 cable will be required . Refer to the Directions for Use of the device to be connected for
3
cable information .
1
2
1000DF00742 Issue 2
Alaris™ Gateway Workstation v1.2
Data Communications Interface Specifications
24/30
Advertisement
Table of Contents
