Table of Contents
Advertisement
Infusion Line Tidies (where fitted)
To assist in the routing of infusion sets and syringe extension sets from the Pumps to the patient, line tidies can be attached to the rear of
the Workstation . The infusion line tidies are height adjustable allowing positioning adjacent to both syringe and volumetric pumps, and
may be mounted on the left or right hand side of the Workstation . To use the infusion line tidies:
1 . Loosen the hand wheel and adjust to the desired position .
2 . Hand tighten the hand wheel to secure the device .
3 . Refit rubber strip .
Note: It is recommended that line tidies be used to organize the infusion lines, this could reduce the
risk of tangled infusion lines and tripping the user or patient .
Alaris Trolley
When the Workstation is mounted to the Alaris Trolley and is not being transported, the brakes should be engaged .
To operate the Alaris Trolley brakes:
1 . Locate brake mechanism at the end of the wheels .
2 . Press down to engage the brakes .
Warning: All wheels that have brakes should be set to the same engaged or disengaged state.
Prior to moving the Alaris Trolley all brakes should be disengaged.
A
Adjustable Height Bag Hangers (where fitted)
The 18 mm diameter adjustable height pole has been designed as a convenient means of securing the fluid bags onto the Workstation .
The pole supports a maximum load to 3 kg . The pole is held securely by a clamp and a slip catch . This gives additional flexibility when
selecting the required height of the fluid bags . To operate the clamp:
1 . Grip the handle at the lower end of the pole and carefully loosen the hand wheel .
2 . Apply an upward pressure to the pole handle, this will release the locking lever and allow
the pole to move freely .
3 . Changing the bag hanger height:
a) To increase the bag hanger height: Continue pushing the pole upward to the required
height . Once set, release the upward pressure on the pole, re-engaging the locking lever .
b) To reduce the bag hanger height: Hold the locking lever in the released position and
adjust the pole downward to the required height . Release the locking lever and release
the upward pressure on the pole, re-engaging the locking lever .
4 . Tighten the hand wheel to securely lock the pole into position .
Caution:
To reduce the risk of excess pressure and siphoning the fluid bag should be placed a minimum height of 300mm
above the Pump.
When bag hanger poles are available they should be adjusted to the height recommended in the specific Pump
A
Directions For Use.
For Workstation configurations 80203UNSxx-235 and 80203UNSxx-035, use the bag hanger assembly PN 1000SP01414
to secure fluid bags onto the Workstation.
3 . Pull up to disengage the brakes .
1000DF00742 Issue 2
Alaris™ Gateway Workstation v1.2
Features of the Workstation
1
3b
2
13/30
4
3
Advertisement
Table of Contents
