Assembly Instructions - Flymo SAMURAI 1000XT Original Instructions Manual

A
3
4
2
1
B1
B2
C
3
2
D
3
2
1
F
1
H
1
2
J2

Assembly Instructions

4
1
E
1
G
1
2
J1
K1
Switch Handle and Handle Tube Assembly (A), (B) & (C)
1. Loosen the four bolts on the Handle Clamp (A).
2. Insert the Switch Handle and the Steady Handle into
the holes at the side of the Handle Clamp (B1 Right
Handed) (B2 Left Handed) - using the Hex Drive
Tool to turn the switch handle (B3)
B3
3. Adjust the Handles to the most comfortable
operating position by moving the Handle Clamp up
or down the tube.
4. Secure the Handle Clamp by tightening the four bolts (C)
Safety Guard Assembly
1. Remove the Nut (D1) and Bolt (D2) from the Safety
Guard (D3).
2. Remove the Cap (E1) and Spool Holder (E2) from
the tube.
3. Locate the Safety Guard (F1) onto the tube.
4. Secure the Safety Guard with the Bolt (G1) and Nut (G2).
2
5. Replace the Spool Holder (H1) and Cap (H2).
Tighten the Cap to secure.
Cable Restraint
1. Form loop in mains cable and push the loop
through the slot (J1).
2. To secure, position loop over the hook and pull the
cable back through the slot (J2).
Adjustable Shoulder Harness
1. Attach the clip on the Shoulder Harness to one of
the holes in the Shoulder Harness Location (K1) to
enable the correct and most comfortable balance
when using the product with the harness fitted
across the body (K2)
Line Cutter Cover
1. Remove the cover on the Line Cutter (L), enabling
the nylon line to be cut to its optimum length when
the product is in use.
K2 L