Kärcher HDS 995 MX Eco Manual page 10

English
Installing the handgun (units
without hose reel)
! Connect steel pipe (item 15) with
handgun (item 20)
! Insert high-pressure nozzle in union nut
! Mount and tighten unit nut
! Install the high-pressure hose to high-
pressure connection of unit. (Figure 6a)
Installing the handgun and the
hose reel (units with hose reel)
! Connect steel pipe (item 15) with
handgun (item 20)
! Insert high-pressure nozzle in union nut
! Mount and tighten unit nut
! Install the hose reel (item 32) with the
provided Allen screws, washers and
nuts (4 of each). (Figure 5)
! Install the high-pressure hose at the
high-pressure connection of hose reel
and unit. (Figure 6b)
! Connect high-pressure hose of handgun
to hose reel
! Wind high-pressure hose onto hose reel
with the smallest possible bends
(direction of turns – clockwise -)
Mounting of spare high-pressure
hose
Fig. 7
Mounting handle
Fig. 8
Water connection
! See Technical Data for connected loads.
! Install supply hose at water connection
(item 18) of unit.
(supply hose is not part of scope of
delivery)
26
Operating Instructions
Drawing in water from tank
When you suction water out of an open
container you should
! remove water connection at pump head.
! screw off the top supply hose with the
fine filter to the water tank and connect
to pump head.
! Use a water suction hose with a suction
filter and a diameter of at least 3/4".
Until the pump sucks up water you should:
! Turn the pressure and flow control to
"MAX".
! close the metering valve for the cleaning
agent.
Warning!
Never suction up water out of a potable
water tank.
Never suction up solvent-bearing liquids
such as paint thinner, benzine, oil or
unfiltered water. The seals in the unit are
not resistant to solvents. The mist of
solvents is highly inflammable, explosive
and poisonous!
Mains connection
See technical data and rating plate for
connected load.
Warning!
It is not permissible to exceed the
maximum permissible mains impedance at
the electrical terminal (see Technical Data).
Warning!
Whenever socket is changed, check
direction of rotation of motor