H3C S5810 Series Quick Start Manual page 38

Item
6. Enter BootRom upgrade menu
7. Skip current configuration file
8. Set BootRom password recovery
9. Set switch startup mode
0. Reboot
If you perform no operation or press a key other than Ctrl + B within one second, once the
remaining waiting time becomes zero, the system begins to automatically start up and the following
information is displayed:
Starting to get the main application file--flash:/S5810_RELEASE.bin!...........
.........................................................
The main application file is self-decompressing................................
...............................................................................
..........................................Done!
System is starting...
Board checking.....................................LSW158150S
Switch chip selftest......................................OK!
SDRAM fast selftest.................................NOT TEST!
Flash fast selftest.......................................OK!
PHY selftest..............................................OK!
CPLD selftest.............................................OK!
Please check port leds..............................finished!
The switch Mac is: 00E0-FC00-5810
User interface aux0 is available.
Press ENTER to get started.
The appearance of "Press ENTER to get started" indicates that the automatic startup of the switch is
completed.
Press Enter. The following prompt is displayed:
<H3C>
You can configure the switch now.
The H3C Series switches provide abundant command views. For detailed descriptions about the
configuration commands and CLI, refer to H3C S5810 Series Ethernet Switches Operation Manual and
H3C S5810 Series Ethernet Switches Command Manual.
Enter the Boot ROM update menu
Skip the current configuration file (this configuration is valid
once)
Restore the Boot ROM password
Set the startup mode of the switch
Restart the switch
4-7
Description