Subscribe to Our Youtube Channel
Related Manuals for Danfoss WS 403
Summary of Contents for Danfoss WS 403
- Page 1 Technical Information Telematics Solutions WS 403 Remote Solution powersolutions.danfoss.com...
- Page 2 Technical Information WS 403 Remote Solution Revision history Table of revisions Date Changed March 2016 Engineering Tomorrow 0203 January 2015 Updates November 2014 Review June 2014 First edition L1426375 | BC00000241en-US0203 © Danfoss | March 2016...
-
Page 3: Table Of Contents
WS 403 Remote Solution Contents About this manual Device elements Device information..................................6 Type label......................................6 Intended use...................................... 7 WS 403 family of telematics units...............................8 Available models....................................8 Cables and antennas..................................8 WS Kits......................................8 Software......................................9 Service and support..................................9 Product conformity WS 403....................................... 10 Compliance with CE.................................10... - Page 4 Technical Information WS 403 Remote Solution Contents WS 403 technical data Mechanical data..................................... 25 Electrical data....................................25 Interface / Protocols / Certifications............................25 Additional features..................................25 Protocols......................................26 Troubleshooting Tests EMC tests......................................28 Electrical loads....................................28 Temperature / climate tests............................... 28 Shock / vibration tests..................................29...
-
Page 5: About This Manual
Technical Information WS 403 Remote Solution About this manual This document is part of the product and provides important information on the intended use, safety, installation and operation of the device(s) described below. The manual is intended for qualified personnel and electricians with advanced knowledge in electrical engineering and fieldbus systems, allowing them to estimate the risks and hazards of operating the device and to integrate it into systems with components of other manufacturers. -
Page 6: Device Elements
This chapter gives an overview of the device elements and functions and also describes the intended use. It further lists the available device variants and the product certifications. Device information The device elements WS 403 is showed in the figure below: 1. 'Power/CAN connector' 2. GSM/3G connector 3. -
Page 7: Intended Use
• Danfoss has no responsibility for any consequences (direct or indirect) caused by failures or malfunctions. • Danfoss has no responsibility for any accidents caused by incorrectly mounted or maintained equipment. -
Page 8: Ws 403 Family Of Telematics Units
ANT GSM QB UMTS GPS K 3M0 FME-F SMA-M FA CAN-Cable M12 5-pol /open 5m On the Danfoss website, you will find documentation and the WS System Tools: various software tools for configuring and deploying the WS device. L1426375 | BC00000241en-US0203 ©... -
Page 9: Software
Device elements Software WS System Tools Product information WS Configurator Download the program from the Danfoss Power Solutions website WS FW Programmer www.powersolutions.danfoss.com Service and support The most recent driver, firmware, tools and documentation versions are available for download from the website. -
Page 10: Product Conformity
System Control Platform. Allow all PLUS+1 ® Service Tool functionalities to be executed remotely and additionally Danfoss Telematics features are added in the Remote Interface (Machine information, signal strength, geographical position linked to Google Maps, CAN Status, Safety mechanism). L1426375 | BC00000241en-US0203 10 | ©... -
Page 11: Safety Information
Technical Information WS 403 Remote Solution Safety information In this chapter, you will find important information on how to avoid life-threatening situations and injuries and how to prevent product damage. General information These instructions are part of the device. They contain text and illustrations for the correct handling of the module and must be read before installation or use. -
Page 12: Air Traffic
Technical Information WS 403 Remote Solution Safety information Air traffic Danger of interference caused by RF energy. The operation of wireless appliances in an aircraft is forbidden to prevent interference with communications systems. Failure to observe these instructions may lead to the suspension or denial of cellular services to the offender, legal action, or both. -
Page 13: Fcc Notice
Technical Information WS 403 Remote Solution Safety information The WS module is protected against power supply polarity reversal, provided an external fuse, max 1 A (Fast) is being used. If this fuse is not used, polarity reversal can damage the unit. Do not connect the housing to Ground externally. -
Page 14: Warranty And Liability
Technical Information WS 403 Remote Solution Safety information Warranty and liability We assume no liability for defects caused by normal wear, external influences, and errors of installation, operating or maintenance. This also applies if the customer itself or third parties without our approval modify the components of our products (e.g. -
Page 15: Device Functions
Data Logging / File Transfer mode Real-time mode CAN messages are received by the device and sent via the Danfoss Web portal server to the remote PC. On this computer there may be an analysis software which can handle the CAN messages. A bi- directional data transfer is possible. -
Page 16: Ws 403 Functionalities
Technical Information WS 403 Remote Solution WS 403 functionalities MCU, RTC and external memory The device has a 32 bit microcontroller ARM Cortex M4. • can be clocked up to 168MHz • extensive peripheral 1MB NOR flash as code memory •... -
Page 17: Gnss Connection
Technical Information WS 403 Remote Solution WS 403 functionalities Supported transmission rates (continued) 236 Kbit/s 236 Kbit/s EDGE 384 Kbit/s 384 Kbit/s UMTS 7.2 Mbit/s HSDPA 5.7 Mbit/s HSUPA GNSS connection The WS unit has an integrated GNSS receiver for position determination that supports the GNS systems GPS, GLONASS and Galileo in the future via firmware update when it is ready. - Page 18 Technical Information WS 403 Remote Solution WS 403 functionalities Inserting the micro-SD card is only possible by unscrewing the housing. The micro SD card is connected via SDIO to the MCU. There are both micro-SD and microSDHC cards. L1426375 | BC00000241en-US0203 18 | ©...
-
Page 19: Connectors
Technical Information WS 403 Remote Solution Connectors WS403 is equipped with the following connectors: • 1x Main connector • 1x GSM connector • 1x GPS connector Main connector The main connector serves for • connecting the WS device to the CAN bus network •... -
Page 20: Gps Connector
Technical Information WS 403 Remote Solution Connectors GPS connector GPS connector SMA, female, front view Designation Description Signal GSM/3G Ground Shield/housing P301 766 L1426375 | BC00000241en-US0203 20 | © Danfoss | March 2016... -
Page 21: Indicator Elements
Technical Information WS 403 Remote Solution Indicator elements The device is equipped with the following indicator elements: • 1x CAN multicolor LED • 1x ON multicolor LED • 1x GSM/3G multicolor LED • 2x GPS multicolor LED If green and red colors are simultaneously on, the LED will appear orange. -
Page 22: Gsm/3G Led States
Technical Information WS 403 Remote Solution Indicator elements GSM/3G LED states Color Light characteristics Description GSM/ 3G green constantly on Connected to a server, TCP/IP active single flash Connecting to a server If double flash does not change into continuously on: No data... - Page 23 Technical Information WS 403 Remote Solution Indicator elements Warning If all LEDs are constantly green at the same time and synchronously flashing red (so all LEDs blinking orange), the device is in firmware update mode. • Do not switch the device off.
-
Page 24: Technical Drawings
Technical Information WS 403 Remote Solution Technical drawings WS 403 UMTS Led’s (4x) P301 767 CAN/power connector 5-pin M12 GSM/3G connector FME GPS connector SMA L1426375 | BC00000241en-US0203 24 | © Danfoss | March 2016... -
Page 25: Ws 403 Technical Data
Technical Information WS 403 Remote Solution WS 403 technical data Mechanical data Device type WS403 Dimensions w / h / l 126 / 128 / 42 mm Standard housing Aluminum, powder-coated Color Charcoal Operating temperature range -30 °C … +75 °C [ -22 °F … 167 °F ] Storage temperature range -40 °C …... -
Page 26: Protocols
Technical Information WS 403 Remote Solution WS 403 technical data Protocols Device type WS403 Layer 2, CANopen L1426375 | BC00000241en-US0203 26 | © Danfoss | March 2016... -
Page 27: Troubleshooting
Technical Information WS 403 Remote Solution Troubleshooting Problem What to do • WS unit does not work properly. Check if the CAN baud rate is set correctly • Check if the wiring is correct (connector pinning) • Check if the CAN network is terminated correctly: measuring 60 Ohms between CAN-H and CAN-L &... -
Page 28: Tests
Technical Information WS 403 Remote Solution Tests EMC tests EMC tests Value Electrostatic discharge immunity test (EN61000-4-2) 6 kV Contact discharge 8 kV Air discharge Electrostatic discharge immunity test (ISO10605:2008) Operation:8 kV contact and 15 kV air discharge Handling: 8 kV... -
Page 29: Shock / Vibration Tests
Technical Information WS 403 Remote Solution Tests Shock / vibration tests Shock / vibration tests Value Vibration (Sinusoidal) EN 60 068-2-6, Test Fc 10 … 22 Hz: 5mm 22…500 Hz: 5g Test time 3 hours per axis Shock EN 60 068-2-27, Test Ea... -
Page 30: Packaging And Transport
Technical Information WS 403 Remote Solution Packaging and transport IP 65 protection is only ensured if all connectors are plugged in. • Do not expose the device to dust and water if the connectors are not plugged in. • Do not immerse the device in water or other liquids. -
Page 31: European Union
Technical Information WS 403 Remote Solution European Union European Union Observe national regulations when disposing the device, accessories and its package. According to the Waste Electrical and Electronic Equipment Directive (WEEE), the device must not be disposed of in the domestic waste but at appropriate collection points. Take the device to a collection point for waste electrical and electronic equipment for correct disposal Alternatively, you can return the device to your dealer for proper disposal. - Page 32 Phone: +86 21 3418 5200 Danfoss can accept no responsibility for possible errors in catalogues, brochures and other printed material. Danfoss reserves the right to alter its products without notice. This also applies to products already on order provided that such alterations can be made without changes being necessary in specifications already agreed.
Need help?
Do you have a question about the WS 403 and is the answer not in the manual?
Questions and answers