Procedure For Loading Diagnostics - IBM 5100 Maintenance Information Manual

PROCEDURE FOR LOADING DIAGNOSTICS
• To load DCP1:
1. Hold theCMD key down and press the HOLD
key.
2.
Hold the CMD key down and press the -
(minus) key.
• To load DCP1 diagnostic mode:
1. Hold the CMD key down and press the
*
or x
(multiply) key.
• To run CMD 0 or 1 tape read tests:
1. Press the C key.
CAUTION
Do not insert the diagnostic tape cartridge until
instructed to do so. If the cartridge is inserted too soon,
the tape may become creased.
2. Hold the CMD key down and press the 0 or 1
key.
0= Internal tape unit test without tape motion
1 = Internal tape unit test with tape motion
DCP2 is now loaded. Select and enter the desired MOl
number from the menu via the instructions on the
display. Press the EXECUTE key and the selected
diagnostic will run.
!
'-
/