Locking Wheel Assembly; Adjustment - IBM 5100 Maintenance Information Manual

(
f
(
..
\
/
(
225
LOCKING WHEEL ASSEMBLY
Adjustment
1. Remove the cartridge stops.
2. Loosen the locking wheel mounting screws
II.
3. Position the locking wheel assembly (4) with the
wheel shaft
B
as shown.
4. Slide the locking wheel assembly to the end of the
slot as shown and tighten the mounting screws.
5. Adjust all four locking wheels in the same manner.
Note: All locking wheels must be adjusted
properly to prevent slippage between the capstan
and spindle.
6. Adjust the cartridge stops (224).
Tape 2-29