IBM 5100 Maintenance Information Manual page 111

(
(
(
After completing the tape read program, the first file of
the CE diagnostic cartridge is loaded into read/write
storage and the following information is displayed:
DCP2
MENU EC.XXXXXX
800 PRINTER MDI
820 COMMUNICATIONS/SERIAL I/O MDI
840 AUXILIARY TAPE MDI
860 TAPE WRITE MDI
890
DIAGNOSTIC ROUTINE CHART
ENTER THE MDI NUMBER TO BE RUN
ENTER
'0'
IF THE OPTIONS ARE TO BE DISPLAYED
§fATUS: ENTER REPLY
XXX XXX is tne current EC number of this CE diagnostic cartridge.
The leftmost dash before the words ENTER THE MOl
NUMBER TO BE RUN flashes to indicate the position of
the next character to be entered from the keyboard. The
procedure for entering the MOl number is found under
MOl in this section.
MOl (MAPs and Diagnostics Integrated)
MOl is MAPs and diagnostic programs integrated into a
single maintenance approach. MOl, with the display and
the keyboard, allows you to isolate machine failures by
responding to information on the display screen.
Questions on the display require a response via the
keyboard. The MOl goes to the next question or section
based on the keyboard input.
Loading MOl Sections
To load MOl sections, select the section from the OCP2
menu, enter the section number, and press EXECUTE.
An 0 {letter) can be entered along with the MOl
sections number (but on the next line) to select a special
option or to alter a previously selected special option.
Then, pressing EXECUTE displays the MOl options.
5100 Diagnostics Overview 3-29