IBM 5100 Maintenance Information Manual page 16

MAP EXAMPLE (continued)
ABC
PROCESS CHECK MAP 0420
1 1 1- _ _ : : - : : - ; - -_ _ _ _ ___
PAGE 2 OF 75 - Off-page reference-indicates the trace and page from
006
Create the PROCESS CHECK.
Did the PROCESS CHECK come on as a
result of pressing RESTART or powering
on the 51007
Y N
008
We will assume that the PROCESS
CHECK comes on as a result of running
a
job.
which this MAP leg came. The 1 indicates that this leg
came from page
1.
The C indicates that this leg came
from trace C.
Go to Step 010, - - - - - - - - - - - - - - I n t e r n a l exit point-indicates the page, step, and entry
Entry Point H. point to go to within this MAP.
007
We will use the RESTART condition to
create the PROCESS CHECK.
Go To Map 0400, Entry Point A. - - - - - - - - - External exit point-indicates the MAP and entry
point to go to.
008
Create the PROCESS CHECK -----------Instruction-establishes conditions for answering the
Go to the INTERMITTENT FAILURE CHART next question.
in the 5100 SERVICE AIDS.
009
Is the PROCESS CHECK intermittent7--------Question-answer either yes or no. Continue from
Y N your answer to the next question or instruction.
010
(Entry Point H)
Bad RESTART switch. -------------Action-possible fixes for the failure. Replace, repair,
Check/replace Z3 (display and control panel) or adjust in the order given. (Check/replace means to
cable (see MAP 0210 and MIM 210, 241). check first, then replace if defective.)
Is the display blank or dark 7
Y N
011
.L._ _____
Reference number-refers to a location graphic,
Are there .an y devices attached to
~
maintenance procedure, chart, or other pertinent
5100 I/O Interface port7 (See XXX information in the maintenance section.
271)
Y N
7 7 1
558
o
E F G
1-10
On-page reference-indicates the trace on this page
from which this leg of the MAP continues. MAPs
normally fill both columns of a page, and an on-page
reference such as this would refer you to material in the
second column.
-~
\.
/