Replacement Of Batteries In Remote Controller - Gree GVH24AK-K3DNC6A Owner's Manual

Replacement of batteries in remote controller

1. Press the back side of remote controller marked
with slightly and then push out the cover of battery
box along the arrow direction.
2. Replace two 7# (AAA 1.5V) dry batteries, and make
sure the position of "+" polar and "-" polar are correct.
Do not mix to use new and old batteries or different
type batteries. Otherwise, it may cause the remote
controller invalid.
3. Reinstall the cover of battery box.
This remote controller can display the res-
idual electricity of batteries. When the icon
of on remote controller is flashing, ple-
ase replace batteries in time. Otherwise, the
remote controller can't operate normally.
Notices for the Operation of Remote Controller
● The distance between remote controller and TV or acoustic device should be
more than 1m. Remote controller should be operated within the receiving
range.
● After remote controller and air conditioner is communicated
successfully, the icon"
will flash. Air conditioner will give out a sound after receiving
valid remote control signal.
● If remote controller can't operate normally, please take out
the batteries. Reinsert batteries after 30s. If they still can't
operate normally, please replace batteries.
● When you don't use remote controller for a long time, please
take out the batteries.
● This remote controller can only be used to operate the air
conditioner which is matched successfully. If you want to
operate other air conditioners with the same type, you should
match them again. However, you can't operate previous air
conditioner with this remote controller.
" on the display of remote controller
17
residual electricity
of batteries
ON/OFF