Operation Guide; Replacement Of Batteries In Remote Controller - Gree GIM09AE Owner's Manual

Function introduction for combination buttons
Note:
1. Memory function does not cover the "Multi Timer".
2. The time calibration of remote controller is not effective after setting "Multi Timer".
3. "Multi Timer" function is prioritized over the original "TIMER ON"and "TIMER OFF"
function.
4. "Multi Timer" function will not be useful any remote controller which does not have
LIGHT button.
5. "Multi Timer" function can be set only in unit off status.

Operation guide

1.
After putting through the power, press "ON/OFF" button on remote controller to
turn on the air conditioner.
2.
Press "MODE" button to select your required mode: AUTO, COOL, DRY, FAN,
HEAT.
3.
Press "▲" or "
be adjusted under auto mode).
4.
Press "FAN" button to set your required fan speed: auto, low speed, low-medium
speed,medium speed, medium-high speed,high speed.
5.
Press " " button to select fan blowing angle.

Replacement of batteries in remote controller

1. Press the back side of remote controller marked
with " ", as shown in the fig, and then push out
the cover of battery box along the arrow direction.
2. Replace two 7# (AAA 1.5V) dry batteries, and
make sure the position of "+" polar and "-" polar
are correct.
3. Reinstall the cover of battery box.
NOTICE
● During operation, point the remote control signal sender at the receiving
window on indoor unit.
● The distance between signal sender and receiving window should be no
more than 8m, and there should be no obstacles between them.
● Signal may be interfered easily in the room where there is fluorescent lamp
or wireless telephone; remote controller should be close to indoor unit during
operation.
● Replace new batteries of the same model when replacement is required.
● When you don't use remote controller for a long time, please take out the
batteries.
● If the display on remote controller is fuzzy or there's no display, please
replace batteries.
" button to set your required temperature. (Temperature can't
18
signal sender battery
reinstall
remove
Cover of battery box