Replacement Of Batteries In Remote Controller - Gree GSA228XA Owner's Manual

Function introduction for combination buttons
● INVADLID OPERATION
1. When the three-minute-counting-down in THREE TIMERS, or the
two-minute-counting-down in TWO TIMERS is due.
2. TIMER commands are not on-off coupled.
3. TIMER spans overlap each other.
4. TIMER span is shorter than 4 minutes.
● INTERACTIVE BUZZING
1. After successfully entering the "Multi Timer" mode, one buzzing will be heard to
prompt that now you can use the "TIMER ON" and "TIMER OFF" buttons to do the
TIMER 1.
2. After successful setting of TIMER 1, two buzzing will be heard to prompt that now
you can use the"TIMER ON"and"TIMER OFF" buttons to do the TIMER 2.
3. After successful setting of TIMER 2, three buzzing will be heard to prompt that
now you can use the"TIMER ON"and"TIMER OFF" buttons to do the TIMER 3.
4. After successful setting of TIMER 3 in THREE TIMERS, or after successful setting
of TIMER 2 in TWO TIMERS, four buzzing will be heard to congratulate you that
"Multi Timer" is done.
5. If there are any invalid operations, or cancellation commands, six buzzing will be heard.
Note:
1. Memory function does not cover the "Multi Timer".
2. The time calibration of remote controller is not effective after setting "Multi Timer".
3. "Multi Timer" function is prioritized over the original "TIMER ON"and "TIMER OFF" function.
4. "Multi Timer" function will not be useful any remote controller which does not have
LIGHT button.
5. "Multi Timer" function can be set only in unit off status.
● This function is only available for some models.

Replacement of batteries in remote controller

1. Press the back side of remote controller marked
the cover of battery box along the arrow direction.
2. Replace two 7# (AAA 1.5V) dry batteries, and
make sure the position of "+" polar and "-" polar
are correct.
3. Reinstall the cover of battery box.
NOTICE
● During operation, point the remote control signal sender at the receiving
window on indoor unit.
● The distance between signal sender and receiving window should be no
more than 8m, and there should be no obstacles between them.
● Signal may be interfered easily in the room where there is fluorescent lamp
or wireless telephone; remote controller should be close to indoor unit during operation.
● Replace new batteries of the same model when replacement is required.
● When you don't use remote controller for a long time, please take out the batteries.
● If the display on remote controller is fuzzy or there's no display, please
replace batteries.
signal sender
Cover of battery box
34
battery
reinstall
remove