Mechanical Design - Siemens SICAM Q100 7KG95 Series Manual

3 Device Design

3.1 Mechanical Design

3.1 Mechanical Design
The device is designed for panel flush mounting. The electrical modules are installed in a plastic case with the
dimensions 96 mm x 96 mm x 100 mm (W x H x D).
The display side of the device contains the display, 4 softkeys located below and 4 LEDs of which the H1, H2,
and ERROR LEDs can be parameterized. The ERROR LED can only be parameterized for error messages.
The device top side holds the RJ45 Ethernet plug connector with 2 LEDs. 4 more LEDs are identical to the
LEDs on the display side. At the cover of the battery compartment, there is a labeling strip for the configurable
LEDs H1/H2 and a battery symbol that indicates the polarity. The label is also on the top side and provides
among other information the most important rated data of the device. A lithium battery is located under the
removable cover of the battery compartment.
SICAM Q100 devices can also contain a D-sub connector plug as RS485 interface (see Figure 3-1) as shown
in the ordering information (see chapter 2.2).
Cover of battery
compartment
LED RUN
LED H1
Softkeys
F1 to F4
Figure 3-1
26
Display side
RJ45 with
2 LEDs
Default IP address
Default subnet mask
Display LED H2
Layout of SICAM Q100
4 LEDs
D sub
(RS485)
LED ERROR
Terminal blocks for
measurements (voltage, current) power supply
E50417-H1040-C522-A6, Edition 06.2019
Terminal side
Binary inputs
Binary outputs
Terminal block for
SICAM Q100, 7KG95xx, Device Manual