Function Button Setting - Sony PVM-740 Operating Instructions Manual

Submenu Setting
WFM/ALM • WFM: A waveform monitor is
SELECT
• ALM: An audio level meter is
When WFM is selected, the waveform
and audio level are displayed. When
ALM is selected, the audio level is
displayed in eight channels.
The audio levels of WFM or ALM are
displayed when SDI signal is input.
Select the displayed audio level channels
in SDI AUDIO SETTING.
The indications of the waveform (only
when WFM is selected) and audio level
signify as illustrated below, although the
percentage of the waveform, units and
values of the scale for the audio level do
not appear on the display.
When WFM is selected
109%
100%
75%
50%
25%
0%
-4%
Channel number
(The channel number which is selected in
SDI AUDIO SETTING is displayed.)
When ALM is selected
Audio level
1 2 3 4 5 6 7 8
Channel number
(Displayed in eight channels, including the channel
which is selected in SDI AUDIO SETTING.)
22
Adjustment Using the Menus
displayed.
displayed.
Waveform Audio level
(dB)
1 2
(dB)
OVER
0
-10
-20
-30
-60
Submenu
POSITION

FUNCTION BUTTON SETTING

USER CONFIG – FUNCTION BUTTON SETTING
F 1 B U T T O N :
F 2 B U T T O N :
F 3 B U T T O N :
F 4 B U T T O N :
F 5 B U T T O N :
F 6 B U T T O N :
F 7 B U T T O N :
Submenu
OVER
0 F1 BUTTON to F7
BUTTON
-10
-20
-30
-60
About the function assigned to the
function button
SCAN
Press the button to change the scan size of the picture.
With every press of the button, the picture switches in
the sequence NORMAL scan t OVER scan t
NATIVE (see "Scan mode image" on page 24).
ASPECT
Press the button to set the aspect ratio of the picture, 4:3
or 16:9.
BLUE ONLY
Press the button to eliminate the red and green signals.
Only blue signal is displayed as an apparent
monochrome picture on the screen. This facilitates
"chroma" and "phase" adjustments and observation of
signal noise.
Setting
Sets the position of the WFM/ALM
display. You can select from among 1 to
4.
• 1: Bottom left
• 2: Bottom right
• 3: Top right
• 4: Top left
xxxx
xxxx
xxxx
xxxx
xxxx
xxxx
xxxx
Setting
Assigns the function to the function
buttons of the front panel and turns the
function on or off.
You can assign the function from among
SCAN, ASPECT, BLUE ONLY,
MONO, MARKER, I/P MODE and
WFM/ALM.
Factory setting
• F1 button: BRIGHTNESS
• F2 button: CONTRAST
• F3 button: CHROMA
• F4 button: SCAN
• F5 button: H/V DELAY
• F6 button: VOLUME
• F7 button: I/P MODE