Using The Stand - Sony PVM-740 Operating Instructions Manual

Press the button BRIGHTNESS, CONTRAST,
CHROMA, or VOLUME function assigned to display
the adjustment screen. Press the same button again, and
the adjustment screen disappears, but you can adjust the
value without the setting value display.
For details of the function assigned to the function
button, see page 22.
h Menu operation buttons
Displays or sets the on-screen menu.
Menu selection control
When the menu is displayed, turn the control to select
a menu item or setting value, and then press the
control to confirm the setting.
To light up the characters that represent the
names of the buttons
When the menu is not displayed, press the menu
selection control. Press it again to turn off the lights.
ENTER button
Press to confirm a selected item on the menu.
When the menu is not displayed, press the button to
display the distinguished signal format.
RETURN button
When the menu is displayed, press the button to reset
the value of an item to the previous value.
When the menu is not displayed, press the button to
display the names of the functions selected in
FUNCTION BUTTON SETTING of the USER
CONFIG menu on the side of the F1 to F7 buttons.
MENU button
Press to display the on-screen menu.
Press again to clear the menu.
i 1 (standby) switch and indicator
Press to turn on the power when this unit is in standby
mode. The indicator lights in green. Press the switch
again to set the monitor in standby mode. The indicator
goes out. If a temperature increase occurs inside the unit
when using the unit in a high temperature environment,
in SILENT MODE, or when a fan error occurs, the
indicator flashes in green and amber alternately. In
power saving mode, it lights in amber.
10
Location and Function of Parts and Controls

Using the stand

Pull the stand toward you to tilt the monitor screen by
15°.
The mounting position of the stand can be changed.
Move the mounting screws on the underside of the stand
to positions A and C, or positions B and C.
A C B
A C B
A and C: Sets the stand towards the back.
B and C: Sets the stand towards the front.
When using the optional VF-510 Monitor ENG Kit, set
the stand at positions B and C.