Setting The Water Jet Intensity; Before Initial Use; Using The Dental Water Jet - Silvercrest NMD 3.7 B2 Operating Instructions Manual

__291789_Munddusche_B6.book Seite 8 Montag, 9. Oktober 2017 4:50 16
8.2 Setting the water jet in-
tensity
You can set three different water jet intensi-
ties on the dental water jet:
LED Jet intensity
soft water jet:
soft at the beginning, for sensitive
gums, for gentle gum massage
normal normal water jet
strong water jet:
for advanced users, strong
jet
gums, intensive cleaning of the
spaces between the teeth
NOTE: if you have not used a dental water
jet before, please start on the soft setting so
that your gums can get used to the water jet.
At a later time you can increase the water jet
intensity to normal and jet. The pressure
should always remain pleasant.
• Press the mode 7 button repeatedly
until the desired LED 10, 9 or 8 is lit.

8.3 Before initial use

1. Rinse the nozzle attachments 2 under
running water.
2. Clean the water tank 19 and the dental
water jet 12 (see "Cleaning / Hygiene
requirements" on page 9).
3. Fill the water tank 19 with clean tap
water (see "Filling the water tank" on
page 7).
4. Insert a nozzle attachment 2 into the
holder 4 so that it clicks into place.
5. Point the nozzle 1 at a washbasin and
switch the dental water jet 12 on with
the on/off switch
6. Let the dental water jet 12 run until the
water tank 19 is empty in order to rinse
8
GB
8.4 Using the dental water
1. Take the dental water jet 12 off the bat-
2. Insert a nozzle attachment 2 into the
3. Fill the water tank 19 with fresh tap wa-
4. To set the water jet intensity, press the
5. Insert the nozzle 1 into your slightly
6. Switch on the dental water jet 12 with
7. To start the cleaning process, direct the
8. Move the nozzle 1 slowly from one
9. To massage your gums, direct the water
10. When no more water is coming out of
6.
through the pipes inside. The dental wa-
ter jet is now ready for use.
jet
tery charger 15.
holder 4 if necessary so that it clicks
into place.
ter.
mode 7 button repeatedly until the de-
sired LED is lit:
- LED soft 10:
soft water jet
- LED normal 9:
normal water jet
- LED jet 8:
strong water jet
open mouth and lean over a washbasin
so that water and rinsed-out food parti-
cles can flow out.
the on/off switch 6.
water jet at the spaces between your
teeth and the edges of the teeth.
Figure C: hold the nozzle 1 in such a
way that the water jet can flush the
food residues away from your gums.
space between two teeth to the next.
Use this method to clean all of the exter-
nal and internal surfaces.
jet at your gums.
the nozzle 1, the water tank 19 is emp-
ty. Switch off the dental water jet 12
and replenish the water tank. When the
device is switched on again, the device