Safety; Safety Advice; Setting Up; Preparing The Remote Control - Silvercrest 91210 Operation And Safety Notes

needles or other sharp objects into them
and thus get an electric shock. Never-
theless, please keep the device out of
the reach of children at all times.
©

Safety

Safety advice

Read these operating instructions and
safety advice carefully. Look at the dia-
gram page and familiarise yourself with
all functions of the device before start-
ing it up for the first time.
Avoid danger to life from
electric shock!
½
Only connect the radio-controlled
sockets to earthed 230 V ~ domestic
sockets.
½
At all costs, avoid exposure to damp
and extreme temperatures.
½
Only use the radio-controlled sockets
in enclosed spaces. They are not
suitable for outdoor use.
½
Despite the child protection socket
, please keep the device out of
8
the reach of children at all times.
½
Avoid overloading the device. Over-
loading can cause a fire hazard or
damage to the device. The maximum
capacity is approx. 2.300 W per
radio-controlled socket.
½
Please contact the service department
immediately operational faults arise.
½
Do not open the device on any ac-
count. All necessary repairs should
only be carried out by the service
Introduction / Safety / Setting up
department or a specialist electrical
workshop.
½
Before cleaning always disconnect
the device from the mains supply. In
this case always remove the radio-
controlled electrical outlet socket from
the mains wall socket and remove
all plugs from the device.
½
Do not have one radio-controlled
electrical outlet socket inserted
behind the other.
½
Do not use any additional child
protection devices for the radio-
controlled sockets. The connection
between the plug and the radio-
controlled socket could be impaired
and risk from overheating then arises.
The radio-controlled sockets already
have a child protection device which
prevents children from putting any
objects into the socket.
½
Make sure that the connected radio-
controlled electrical outlet sockets are
freely accessible and not covered by
other objects.
½
If the device malfunctions, switch it
off immediately.
½
These instructions are a component
of the device. If you pass the device
on to a third party, these instructions
must also be handed on.
©

Setting up

©
Preparing the remote
control (fig. A)
1. Open the battery compartment on
the back of the remote control by
GB 31