Connecting To A Power Source; Connecting To An Ac Power Source - Cisco Catalyst 9600 Series Hardware Installation Manual

Connecting to a Power Source

Figure 43: Installing the Power Cord Retainer
Step 8 Set the power switch to the ON (|) position
What to do next
Connect the power supply to the power source.
Connecting to a Power Source
The following sections provide information about connecting the chassis to an AC and DC power source.

Connecting to an AC Power Source

To connect to a power source, follow these steps:
Warning Take care when connecting units to the supply circuit so that wiring is not overloaded. Statement 1018
Cisco Catalyst 9600 Series Switches Hardware Installation Guide
82
1 Power supply fully inserted into the chassis; power cord and retainer strapped into
place.
Installing a Power Supply Unit