Cisco Catalyst 9600 Series Hardware Installation Manual page 85

Installing a Power Supply Unit
Installing a Power Supply Module
Figure 42: Plugging in the Power Cord
1 Power cord plugged into the receptacle
Step 7
Follow the steps to install the power cord retainer, to hold it in place and avoid accidental removal.
a) Fix the strap in the power cord retainer to the power supply module, to hold the clamp in place.
b) Slide the retainer clamp around the power cord and position the retainer closest to the power supply.
Depending on the width of the power cord, adjust the size of the retainer clamp, if required.
c) Press the tabs on the retainer clamp towards each other to secure the power cord.
Cisco Catalyst 9600 Series Switches Hardware Installation Guide
81