Cisco Catalyst 9600 Series Hardware Installation Manual page 17

Preparing for Installation
Warning
Ultimate disposal of this product should be handled according to all national laws and regulations. Statement
1040
Warning To prevent the system from overheating, do not operate it in an area that exceeds the maximum recommended
ambient temperature of 104°F (40°C). Statement 1047
Warning
Stability hazard. The rack stabilizing mechanism must be in place, or the rack must be bolted to the floor
before you slide the unit out for servicing. Failure to stabilize the rack can cause the rack to tip over. Statement
1048
Warning
The chassis should be mounted on a rack that is permanently affixed to the building. Statement 1049
Warning
Invisible laser radiation may be emitted from disconnected fibers or connectors. Do not stare into beams or
view directly with optical instruments. Statement 1051
Warning Class 1M laser radiation when open. Do not view directly with optical instruments. Statement 1053
Warning Class I (CDRH) and Class 1M (IEC) laser products. Statement 1055
Warning Invisible laser radiation may be emitted from the end of the unterminated fiber cable or connector. Do not
view directly with optical instruments. Viewing the laser output with certain optical instruments (for example,
eye loupes, magnifiers, and microscopes) within a distance of 100 mm may pose an eye hazard. Statement
1056
Cisco Catalyst 9600 Series Switches Hardware Installation Guide
Safety Warnings
13