Removing The Fan Tray From The Rear Of The Chassis - Cisco Catalyst 9600 Series Hardware Installation Manual

Installing the Fan Tray
Figure 34: Removing the Captive Installation Screws
1
Step 3
Grasp the fan tray handle and slide the fan tray half-way out of the bay. Gently move it from side to side, if
necessary, to unseat it from the backplane.
Step 4
Wait for the fan blades to stop spinning; place your other hand underneath to support the bottom of the fan
tray and then remove the fan tray completely.
Only the fan tray is removed from the chassis (excluding the connector).
What to do next
Set the removed fan tray aside and proceed with installing the replacement or spare fan tray.

Removing the Fan Tray from the Rear of the Chassis

When you remove the fan tray from the rear, the fan tray assembly is removed. This includes the fan tray and
the connector.
Captive installation screws on the front of the fan tray assembly in the chassis
Cisco Catalyst 9600 Series Switches Hardware Installation Guide
Removing the Fan Tray from the Rear of the Chassis
67