ABB IRC5 Product Manual page 174

4 Repair
4.10 Replacement of SD-card memory in computer unit
Continued
Removal
Use the following procedure to remove the SD-card memory.
1
2
3
Refitting
Use the following procedure to refit the SD-card memory.
1
2
3
4
5
174
Action
DANGER
Before commencing any work inside the cabinet, please observe the safety inform-
ation in section Make sure that the main power has been switched off on page
ELECTROSTATIC DISCHARGE (ESD)
The unit is sensitive to ESD. Before handling the unit please observe the safety
information in section
Gently push the SD-card memory with your finger until it clicks, and then pull it
straight out.
Action
DANGER
Before commencing any work inside the cabinet, please observe the safety information
in section Make sure that the main power has been switched off on page
ELECTROSTATIC DISCHARGE (ESD)
The unit is sensitive to ESD. Before handling the unit please observe the safety inform-
ation in section The unit is sensitive to ESD on page 32
CAUTION
Make sure that the SD-card memory is correctly oriented before inserting it. Otherwise
the SD-card memory or the SD-card memory slot may be damaged.
Gently push the SD-card memory with your finger until it clicks into place.
Perform the function tests in section
features work properly.
© Copyright 2007-2018 ABB. All rights reserved.
The unit is sensitive to ESD on page 32
Function tests on page 135
Product manual - IRC5 Panel Mounted Controller
25.
25.
to verify that the safety
3HAC047137-001 Revision: J