At+Cmer Mobile Equipment Event Reporting - Ericsson T39 At Command Reference

Example:
AT+CMER Mobile Equipment Event Reporting
Description:
Set command:
Read command:
Test command:
Test command
response:
Parameters:
<mode>:
<keyp>:
<descr>
"call"
"roam"
"smsfull"
AT+CIND?
+CIND: 2,3,1,1,1,1,1,0,0,1
OK
AT+CIND=?
+CIND: ("battchg",(0-1)),("signal",(0-5)),
("batterywarning",(0-1)),("chargerconnected",(0-1)),
("service",(0-1)),("sounder",(0-1)),("message",(0-1)),
("call",(0-1)),("roam",(0-1)),("smsfull",(0-1))
Enables or disables the unsolicited result codes
display changes, and indicator state changes.
AT+CMER=[<mode>[,<keyp>[,<disp>[,<ind>[,<bfr>]]]]]
AT+CMER? Displays the current <mode>, <keyp>, <disp>, <ind>, and <bfr>
settings.
AT+CMER=? Shows if the command is supported.
+CMER: (list of supported <mode>s),(list of supported <keyp>s),(list of supported
<disp>s),(list of supported <ind>s),(list of supported <bfr>s)
<mode>
0
3
<keyp>
0
2
Description
Call in progress (0-1)
Roaming indicator (0-1)
(Home net status, '0' = Home Net)
A short message memory storage in the MT has become full
('0'), or memory locations are available ('1')
+CKEV
Description
Buffer unsolicited result codes in the TA
If the TA result code buffer is full, codes can be buffered
elsewhere, or the oldest result codes can be removed to make
room for the new result codes
Default setting
Forward the unsolicited result codes directly to the TE;
TA-TE link-specific inband technique used to embed result
codes and data when TA is in on-line data mode.
Description
No keypad event reporting
Default setting
Keypad event reporting using
Enables keypad event reporting of all key presses
AT Commands Phone Terminal Terminated
and +CIEV for key presses,
+CKEV
72