Disassembly Instructions; Detaching Method Of The Terminal With Locking Mechanism; Removing The Cabinet And The Panels - Mitsubishi Electric MXZ-2C20NA2-U1 Service Manual

12

DISASSEMBLY INSTRUCTIONS

<Detaching method of the terminal with locking mechanism>
The terminal which has the locking mechanism can be detached as shown below.
There are following 2 types of the terminal with locking mechanism.
The terminal without locking mechanism can be detached by pulling it out.
Check the shape of the terminal before detaching.
(1) Slide the sleeve and check if there is a locking lever or not.
Sleeve
Lockin lever
12-1. MXZ-2C20NA2
OPERATING PROCEDURE
(1) Remove all the screws of the service panel, and remove
the service panel.
(2) Disconnect the power supply cord and indoor/outdoor
connecting wires.
(3) Remove all the screws of the top panel, and remove the
top panel.
(4) Remove all the screws of the cabinet, and remove the
cabinet.
(5) Remove all the screws of the back panel, and remove the
back panel (Photo 3).
Photo 3
Screw of the rear guard
Screws of the
back panel
Screws of
the back panel
OBH702G
(2) The terminal with the connector shown below
Slide the sleeve.
Pull the terminal while
pushing the locking
lever.
Screws of the
back panel
102
has the locking mechanism.
Hold the sleeve, and
pull out the terminal
slowly.
Connector
: Indicates the visible parts in the photos/figures.
: Indicates the invisible parts in the photos/figures.
Photo 1
Screws of the cabinet
Photo 2
Screws of the
top panel
Screws of
the cabinet
Screws of the
top panel
Screws of
the cabinet
Screws of
service
panel
Screws of Screws of the
the cabinet sub panel