Rebuilding virtual drives
This section describes a procedure of rebuilding virtual drive in case of trouble
that has occurred on a physical disk in the redundant disk array configuration.
Usually, rebuilding will work automatically after you replace the failed disk in
hot-plug. Also, if you set up hot spares, rebuilding will work automatically.
The following is a procedure of manual rebuilding in case that rebuilding doesn't
work automatically by some reason.
1. Click Drives in the main menu.
2. The following window is displayed.
Click a disk status is Offline, and then click Rebuild > Go.
MegaRAID WebBIOS
2-63
Hitachi Compute Rack 210H/220H BIOS Guide