Aiwa NSX-MT960 Operating Instructions Manual page 26

6
1,2, 3,4
2,3,4
The unit can be turned on at a specified time every day with the
built-in timer.
Preparation
Make sure the clock is set correctly (see page 24).
1
2
3
Press CLOCWTIMER twice to display ~, then
press 1I SET within 6 seconds.
O
is displayed, and the hour flashes.
When using the remote control
Press TIMER, then press II SET within 6 seconds.
m
If you press II SET after 6 seconds, another operation may
start.
Designate the hour of the timer-on time by
pressing - DOWN or FF UP, then press II
SET. Repeat to designate the minute of the timer-
After you designate the timer-on time, one of the source names
flashes on the display.
Press + DOWN or FF UP to select a source,
then press II SET.
If TUNER is selected, the band cannot be selected in this
step.
4
5
6
Select the duration for the timer-activated period
with + DOWN or _ UP, then press II SET.
The duration for the timer-activated period can be set between
5 and 240 minutes in 5-minute steps.
Prepare the source.
To
listen to a CD,
load the disc to be played first on tray 1.
To listen to a tape, insert the tape into deck 1 or 2.
To
listen to the radio,
tune into a station.
Press POWER to turn the unit off after adjusting
the volume and tone.
@
remains on the display after the power is turned off (timer
standby mode).
When the timer-on time is reached, the unit turns on and
begins play with the selected source.
The volume level is automatically set to 20 when the power
is turned off with the volume level set to 21 or more.
To check the specified time and source
Press TIMER once on the remote control. The timer-on time, the
timer-activated period and the selected source name are
displayed for 4 seconds.
To cancel timer standby mode temporarily
Press TIMER on the remote control repeatedly until 0 or @REC
disappears on the display.
To restore the timer standby mode, press TIMER again once or
twice to display@ or @REC.
Using the unit while the timer is set
You can use the unit normally after setting the timer.
Before turning off the power, repeat step 5 to prepare the source,
and adjust the volume and tone.
m
Timer playback and timer recording will not begin unless the
power is turned off.
Connected equipment cannot be turned on and off by the built-
in timer of this unit. Use an external timer.
Timer recording is applicable for TUNER and Vi DEO/AUX (with
an external timer) sources only.
Press TIMER on the remote control repeatedly until @ REC
appears on the display, then press II SET
within
6 seconds.
Carry out the steps of "SETTING THE TIMER" from step 2 and
insert the tape to be recorded into deck 2 after step 5,
'MULTI JOG is also available instead of +4 and W,
ENTER is also available instead of II SET
25
ENGLISH