Aiwa NSX-MT960 Operating Instructions Manual page 25

1,
1
2
3
CLOCK
Press CLOCIVTIMER once, then press II
SET
within 4 seconds.
The hour flashes.
When using the remote control
Press CLOCK, then press II SET within 4 seconds.
Press < DOWN or ~ UP to designate the
hour, and press II SET.
The hour stops flashing and the minute starts flashing.
Press + DOWN or - UP to designate the
minute and press II SET.
The minute stops flashing on the display and the clock starts
from 00 second.
To
display the current time
Press CLOC~IMER once. The time is displayed for 4 seconds,
However, the time cannot be displayed during recording.
To
switch to the 24-hour standard
Press CLOCK/TIMER once, then press within 4 seconds.
Repeat the same procedure to restore the 12-hour standard.
If the clock display flashes
This is caused by a power interruption. The current time needs
to be reset.
If power is interrupted for more than approximately 24 hours,
all settings stored in memory after purchase need to be reset.
1
2
The unit can be turned off automatically at a specified time.
Use the remote control.
1
Press SLEEP.
2 Within 4 seconds, press ++ or - to specify
the time until
the power is turned off.
Each time the button is pressed, the time changes between 5
and 240 minutes in 5-minute steps.
Specified time
To check the time remaining until the power is turned off
Press SLEEP once. The remaining time is displayed for 4
seconds.
To cancel the sleep timer
Press SLEEP twice so that "SLEEP oFF appears on the display.
*MULTI JOG is also available instead of U and -.
*MULTI JOG is also available instead of U and ~.
ENTER is also available instead of // SET.
ENGLISH
24