Aiwa NSX-MT960 Operating Instructions Manual page 20

4
2
8
1
3,7
[~1
. . .? .___ —–-.–– ..-
~""" "-" '-""'"
5
Programmed edit recording function enables tracks programming
while checking the remaining time on each side of the tape as
the tracks are programmed.
m
The programmed edit recording will not start from a point halfway
in the tape. The tape must be recorded from the beginning of
either side.
1
2
3
4
5
Insert the tape into deck 2, and press DOLBY NR
to turn Dolby NR on or off.
Insert the tape with the side to be recorded on first facing out
from the unit.
Press CD and load the disc(s).
Press CD EDIT/CHECK twice.
EDIT lights up and 'rPRGM" flashes on the display.
When using the remote control, press EDIT/CHECK twice.
When "Al" is displayed, press CD EDIT/CHECK again.
Press +
or ~ to designate the tape length.
10 to 99 minutes can be specified.
The numbered buttons O-9 or MULTI JOG are also
available to designate the tape length.
Maximum recording
Tape le~gth
Tape sidel(A) tirye for side A
Press DISC DIRECT PLAY, then press numbered
buttons 1-5 within 3 seconds on the remote
control to select a disc. Then press numbered
buttons O-9 and +1 O to program a track.
Examp/e:
To select the 10th track of disc 2, press DISC
DIRECT PLAY and numbered button
2, then
press
+1 O
and
o.
6 Repeat step 5 for the rest of the tracks for side A.
A
track whose playing time is longer than the remaining time
cannot be programmed.
Selected track number
Selected disc Program number
Remaining time Programmc
number of side A
tracks
7 Press CD EDIT/CHECK to select side B and
program the tracks for side B.
After confirming Bon the display, repeat step 5.
Tape side B (reverse side)
8 Press REC/REC MUTE to start recording.
The tape is rewound to the beginning of the front side, the
lead segment is played through for 10 seconds, and recording
starts. When, recording on the front side (A) ends, recording
on the back side (B) starts.
To stop recording
Press . Recording and CD play stop simultaneously.
To check the order of the programmed track numbers
Before recording,
press CD EDIT/CHECK to select side A or B,
and press + or - repeatedly or turn MULTI JOG.
Disc number Program number
I
I
Track number Programmed track numbers
To change the program of each side
Press CD EDIT/CHECK to select side A or B, and press
CLEAR to clear the program of the selected side. Then program
tracks again.
To clear the edit program
Press twice so that "EDIT" disappears on the display.
m
Recording is inhibited if the erasure prevention tab on either
side of the tape is broken off.
Up to 30 tracks can be programmed from any of the inserted
discs.
I 9
ENGLISH