Aiwa NSX-MT960 Operating Instructions Manual page 22

MANUAL
SELECT
2
1
W
DOWN,
FPl UP
1
2
Press VIDEO/AUX and start playback of the video
source.
"VIDEO is displayed.
If "5.1 ch IN" is displayed, press VIDEO/AUX again.
Press DOLBY PRO LOGIC.
"NORMAL' is selected, and the playback sound has the
DOLBY PRO LOGIC effect.
To cancel Dolby
Pro Logic mode
Press DOLBY PRO LOGIC repeatedly until "P-OFF is displayed.
To
change the sound levels during playback
After adjusting the balance with the noise sequencer, the sound
levels of the center or each surround speaker can be adjusted
during playback of laser discs or video software.
1
Press MANUAL SELECT (TEST) on the remote control
repeatedly to select "CEN" (center) or "S-R" (right surround
speaker) or "S-L' (left surround speaker).
2 While the "CEN" or "S-R" or "S-L' is displayed, press DOWN
K or UP M on the remote control to adjust the volume.
In addition to the NORMAL mode, this unit is also equipped with
the PHANTOM and the 3 STEREO modes.
PHANTOM mode: Use this mode when no center speaker is
connected. The center channel signals are output through the
left and right speakers.
3 STEREO
mode:
Use this mode when no surround speakers
are connected. This mode reproduces rear sounds through the
front speakers.
To select PHANTOM or 3 STEREO
Press DOLP~ PRO LOGIC repeatedly until the desired Dolby
Pro Logic mode is displayed. The DOLBY PRO LOGIC mode is
displayed cyclically as follows.
~ NORMAL+
PHANTOM --+ 3 STEREO
7
~ P-OFF (cancel) ~
m
. Depending on the sound source andlor listening conditions, a
surround effect may not be obtained even when the Dolby Pro
Logic is on.
The full DOLBY PRO LOGIC effect cannot be obtained when
using software without lltllm~=~wnl mark. In this case, use
the SURROUND system instead. (See page 9.)
The DOLBY PRO LOGIC is automatically cancelled when:
- the ECHO level is changed.
- the SURROUND system or BBE is turned on.
- the headphones are plugged in.
- the Karaoke function is turned on.
- the 5.1 CH (page 27) is selected.
Set the microphone volume to OFF while the DOLBY PRO
LOGIC is on. Otherwise, the DOLBY PRO LOGIC sound cannot
be reproduced correctly.
To
adjust the balance of connected speaker sound levels
Carry out steps 2 to 4 of "ADJUSTING SPEAKER LEVEL
BALANCE" (page 20).
21
ENGLISH