Motorola SE4710 Integration Manual page 50

5 - 2 SE4710 Integration Guide
SE4710 Command List (Continued)
Table 5-1
2
I C Command Set
FRAME_RATE
GET_EXTENDED_STATUS
GET_FSTATS
GET_PARAM
ILLUMINATION_DURING_EXPOSURE
ILLUMINATION_POWER_LEVEL
IMAGE_CROPPING
IMAGE_RESOLUTION
IMAGER_INTERFACE_TYPE
LCD_MODE
MIRROR_AND_FLIP
PICKLIST_MODE
PING
POWER_MODE
RD_SENSOR
RESET
TIME_TO_LOW_POWER
WR_SCRIPT
WR_SENSOR
Opcode
0x5E Sets the frame rate.
0x79 Gets the SE4710 operating states.
0x81 When issued, the command returns a response
containing information about the last captured frame.
0x70 Gets SE4710 parameters.
0x59 Turns illumination on and off.
0xF0 Sets the illumination brightness level.
0x5D Crops the output image.
0x5C Sets the resolution of the output image.
0x86 Set the camera interface to MIPI or parallel.
0x82 Enables and disables LCD mode.
0x85 Mirrors and/or flips the image.
0x7B Enables and disables Picklist mode.
0x7A Used for test purposes.
0x5F Places the SE4710 in low power mode.
0x51 Reads the OmniVision OV9212 registers.
0x57 Returns engine components to a default state.
0x75 Sets the length of time the SE4710 is idle before
entering low power mode.
0x76 Programs more than one SE4710 command into one
script.
0x50 Writes to the OmniVision OV9212 registers.
Description Page
5-6
5-7
5-7
5-7
5-7
5-8
5-8
5-8
5-8
5-8
5-8
5-9
5-9
5-9
5-9
5-9
5-9
5-10
5-10