5 - 6
SE4710 Integration Guide
It is up to the host to determine the correct drive strength level based on signal integrity and electromagnetic
compatibility requirements. The default is 3.3V low.
ENTER_BOOTLOADER 0x91
In this mode, the SE4710 protocol changes and no longer supports this I
necessary for firmware updates.
EXEC_INLINE 0x83
The command allows more than one engine command to be executed inline without first writing it to the engine.
This method could be used for scripts that do not need to be executed more than once.
Example:
To execute inline with AIM-ON, ILLUM-ON, and ACQUISITION-ON the command is as follows:
<0x83><0x00><Len><C1Len><C1Op><C1Data><C2Len><C2Op><C2Data><C3Len><C3Op><C3Data><CS>
or
<0x83><0x00><0x09><0x02><0x55><0x01><0x02><0x59><0x01><0x02><0x58><0x01><0x70>
NOTE SE4710 buffer size = 150 byte max
EXECUTE_SCRIPT 0x77
After programming a script (via the WR_SCRIPT command), use this command to execute it.
EXTERNAL_ILLUMINATION 0x5A
Controls operation of the EXT_ILLUM_EN signal on the SE4710 host connector.
FRAME_RATE 0x5E
Sets the frame rate.
2
C command set. Bootloader mode is