Illumination_Power_Level 0Xf0; Image_Cropping 0X5D; Image_Resolution 0X5C; Imager_Interface_Type 0X86 - Motorola SE4710 Integration Manual

5 - 8 SE4710 Integration Guide

ILLUMINATION_POWER_LEVEL 0xF0

Sets the SE4710 illumination power (brightness) level. The valid ranges are from 1 to 27. The default is 7, or
100mA. Each count is in 12.5mA increments. It is not recommended to go below 7 due to the non-linearity of the
illumination LED response.

IMAGE_CROPPING 0x5D

Crops the output image.

IMAGE_RESOLUTION 0x5C

Sets the resolution of the output image.

IMAGER_INTERFACE_TYPE 0x86

Use this command to output image data in MIPI or parallel.
The engine uses a single connector for both MIPI and parallel. The interface must be configured prior to
NOTE
an acquisition start command.

LCD_MODE 0x82

Enables and disables LCD mode. This command has two parameters:
•
Number of No-light Frames (LCD frames)
•
Total Number of Frames
Setting the Number of No-light Frames to 0 disables LCD mode. Setting the Number of No-light Frames to 1
enables LCD mode. The Total Number of Frames field is ignored.
This command works in conjunction with ACQUISITION Start. Configure LCD_MODE before starting acquisition.
When acquisition starts, the LCD mode sequence begins. Disable LCD mode (by setting the number of LCD
frames to 0) after stopping acquisition. To track cell phone frames issue the GET_FSTATS command after every
frame. The statistics byte specifies whether the frame was the LCD frame.

MIRROR_AND_FLIP 0x85

Use this command to mirror and/or flip the output image.