Related Manuals for Clarke Air AP15
Summary of Contents for Clarke Air AP15
- Page 1 HVLP SPRAY GUN HVLP SPRAY GUN MODEL NO: AP15 PART No: 3090100 OPERATION & MAINTENANCE INSTRUCTIONS 0903...
- Page 2 CLARKE GUARANTEE This CLARKE product is guaranteed against faulty manufacture for a period of 12 months from the date of purchase. Please keep your receipt as proof of purchase.
- Page 3 Parts List 11 / 12 Please note that the details and specifications contained herein are correct at the time of going to print. However CLARKE International reserve the right to change specifications at any time without prior notice. - 3 -...
-
Page 4: Safety Precautions
SAFETY PRECAUTIONS WARNING Compressed air can be dangerous. Ensure that you are thoroughly familiar with all precautions relating to the use of compressors and compressed air supply. For your personal safety and that of others around you. Follow these safety instructions carefully. NOTE : products used in this spray gun may be covered by COSHH Regulations. - Page 5 GENERAL ARRANGEMENT A. Paint Cup G. Knurled Locking Ring Air Inlet H. Wings C. Spray Width Adjuster Nozzle D. Trigger. Paint Cup Vent Fluid Control Adjuster Cup Locking Lever Air Adjuster AIR SUPPLY HVLP AP15 spray guns are available with one nozzle size (2.2mm), ensure your spray gun is matched to the capacity of your compressor.
- Page 6 USING THE SPRAYGUN HVLP AP15 spray guns are fed with paint by syphon or suction from the paint cup. The air flow through the air cap draws paint into the nozzle assembly, where it is atomised and sprayed forward. Mix the paint to the correct viscosity for spraying according to the manufacturers instructions, and strain it into the paint cup through a fine mesh filter.
- Page 7 MAINTENANCE WARNING Disconnect the spray gun from the air supply, and relieve any pressure in the gun and hose, before any disassembly. It is essential that the spray gun is kept clean. Dried paint in the nozzle assembly or airways will stop the gun from working.
-
Page 8: General Preparation
PAINT SPRAYING HINTS WARNING NEVER attempt to spray unless you are wearing suitable, approved respiratory and eye protection. REMEMBER that some modern paints require specialist respiratory protection...always consult the paint manufacturers instructions. 1. General Preparation a. Ensure that the area in which you will be spraying is clean and dust free. b. - Page 9 PAINT SPRAYING HINTS Cont To obtain best results, it is vital that the surface to be sprayed is well prepared. It must be clean, free from dust, dirt and grease. Mask any area that is not to be sprayed. Paint Thinning Thinning is particularly important when paint spraying.
- Page 10 PARTS & SERVICE TEL: 020 8988 7400 e-mail as follows: PARTS: Parts@clarkeinternational.com SERVICE: Service@clarkeinternational.com - 11 -...
- Page 11 PARTS LIST AP15 DESCRIPTION PART NUMBER Nozzle Set NS1701 Fluid Nozzle NS530104 Packing Screw For paint Needle NS1705 Self Tensioning Needle Packing NS1706 Washer NS1707 Spring NS1708 Brass Ring NS530109 Gasket NS1710 Gun Body NS9313 Screw NS9122 Paint Needle Complete NS9016 Spring NS9617...