Tektronix 2215 Instruction Manual page 319

Page 6-18 After the Current Limit Circuit Board procedure
A D D :
Preregulator Circuit Board
perform the following steps:
"High-Voltage Shield" removal procedure).
board mounting brackets (one at the rear-top of the
frame and one on the right side near the back corner
of the frame).
access hole of the clear plastic shield from the top
of the Preregulator board at the front-right corner.
Preregulator board and note their positions for
reinstallation reference.
installed. Use
board-removal procedure
particular instrument.
To remove the Preregulator circuit board,
1. Remove the High-Voltage shield (see the
2. Remove two screws securing the Preregulator
3. Remove the securing screw through the
4. Disconnect four wire connectors from the
Page 6
the appropriate
for your
of 16