While Editing - Sony MZ-B10 Operating Instructions (primary manual) Operating Instructions Manual

Symptom
There is no R-
channel sound
output when
playing a track
recorded from a
cassette deck or
through an
amplifier, or when
listening to sound
from a cassette
deck or amplifier.
The optional foot
control unit does
not work properly.

While Editing

Symptom
The lid does not
open.
Editing cannot be
done.
Track marks
cannot be erased.
The disc cannot
edit on other
component.
Cause/Remedy
• There is no R-channel output if the cassette deck or an amplifier is
connected with a monaural cord.
, Make sure to use a stereo connecting cord. If, however, the
connected equipment is monaural, there will be no R-channel
sound output even with a stereo connecting cord.
• The recorder is not set for foot control unit use.
, Set "FOOT SW" in the menu to "SW ON" (page 40).
Cause/Remedy
• The power sources have been disconnected during recording or
editing, or the battery have been exhausted.
, Set the power sources again, or replace the exhausted battery
with new ones and press x • STOP.
• The power source has been disconnected or a power outage has
occurred during editing.
, The editing done to that point is not saved to the disc. Do the
editing operation again.
• This is due to the MiniDisc system limitations. When the data of a
track is fragmented, the track mark of a fragment under 12 seconds
long (recorded in stereo), 24 seconds long (recorded in LP2 stereo
mode or monaural mode), or 48 seconds long (recorded in LP4
stereo mode) cannot be erased. You cannot combine a track
recorded in stereo and a track recorded in monaural; nor can you
combine a track recorded with digital connection and a track
recorded with analog connection.
• The component does not support MDLP.
, Edit on other component that support MDLP.
51