Adding Track Marks While Recording; Adding Track Marks Manually; Adding Track Marks Automatically (Auto Time Mark) - Sony MZ-B10 Operating Instructions (primary manual) Operating Instructions Manual

Notes
• The pause function cannot be turned on or off
manually during synchro-recording.
• Do not switch the "SYNC REC" setting while
recording. Recording may not be done
properly.
• You cannot change the recording mode during
recording.
• Even when there is no sound on the sound
source, there may be cases when recording
does not pause automatically during synchro-
recording due to the noise level emitted from
the sound source.
• If a silent portion is encountered for
approximately 2 seconds during synchro-
recording from a sound source other than a
CD or an MD, a new track mark is
automatically added at the point where the
silent portion ends.
• Synchro-recording cannot be done if the
connecting cord is not an optical cable, or if
the cable is connected to the MIC (PLUG IN
POWER) jack.
24
Adding track marks
while recording
You can add track marks (track number)
while recording to divide the material into
separate parts.
. • REVIEW •
AMS, > • CUE •
AMS

Adding track marks manually

1
While the recorder is recording, press
TRACK MARK.
Adding track marks
automatically (Auto Time
Mark)
Use this feature to add track marks
automatically at 10-minute intervals when
recording through the analog input
connector or a microphone. This function
is convenient when making a long
recording, e.g., of a lecture or meeting.
1
While the recorder is recording or in
recording pause, press MENU/
ENTER.
2
Press . or > until "REC SET"
appears in the display, and then press
MENU/ENTER.
3
Press . or > until "TIME
MARK" appears in the display, and
then press MENU/ENTER
MENU/
ENTER
TRACK
MARK
.